Wall Mounting Bracket EVR1
Wall Mounting Bracket for EVR1 series
(control-box and cable holder)
By buying this product you can collect up to 3 loyalty points. Your cart will total 3 points that can be converted into a voucher of 1,50 €.
Wall Mounting Bracket for Portable Charging Stations EVR1.
This holder will help you to get the most out of your EVR1 portable station for every-day charging operations.
Place an holder where you charge your EV every day, so your portable station will become a comfortable to use Wall-Box.
When you have to go away with your EVR1:
Simply pull the plug, slip off the EVR1 from the holder and put it into the supplied bag.
Un support simple et fonctionnel
Ce support permet de fixer la borne de recharge amovible et portable EVR1,
il permet également d'enrouler le câble de chargement
Very good tool to support the charger.
Very good tool to support the charger, but was limited to where it could be installed due to short cord from main unit to wall socket.
But nice and tidy installation for my charger
Thank you for your product review on our website. We always welcome feedback, whether it is positive or negative.
In charging stations which comply with Mode 2 according to IEC 61851-1, the control box on the cable (the circuit board) must be within 30 cm. of the power plug (CEE).
For this reason, all Mode 2 and CE Mark charging stations have a box fitted near the power plug containing the electronic control unit, because correct earth contact cannot be checked in the cable section that connects the plug to the electronics, which is essential for the safety of users.
Therefore the maximum allowed length of the input cable is 30cm.